| socket. Step 3: Pull/Push away the two white clips located on both sides of
the VRM socket such that the PCB (printed circuit board) insertion area of the socket is
unobstructed.
Step 4: Gently place the VRM into the VRM
socket, making sure that all pins are well matched and covered by the module.
Step 5: Press down on the VRM along the edge
facing up until you hear or see the two white clips lock into the VRM's side notches.
SETTING THE VOLTAGE
==================================================
VOLTAGE
JP1A
JP1B
JP1C JP1D
--------------------------------------------------------------------------------------------------
3.5V
SHORT
OPEN
OPEN OPEN
2.9V
OPEN
SHORT
OPEN OPEN
2.8V
OPEN
OPEN
SHORT OPEN
2.7V
OPEN
OPEN
OPEN SHORT
2.5V
OPEN
OPEN
OPEN OPEN
==================================================
REMOVAL
Simply press down on the two white clips and the VRM will be lifted out of the
socket for easy extraction. Replace the four red jumpers as illustrated below: |
